How to Set Up Your Art 'N Glow 10-Gallon Epoxy Resin Kit

Do you want to know how to set up your Art ‘N Glow 10 Gallon Clear Casting and Coating Epoxy Resin Kit in 5 easy steps?

Well, read on and learn more about this process!

Here Are 5 Steps in Setting up Your Art ‘N Glow 10 Gallon Clear Casting and Coating Epoxy Resin Kit

STEP 1

Unbox your Art ‘N Glow 10 Gallon Clear Casting and Coating Epoxy Resin Kit 

You will receive one 5-gallon jug of resin and one 5-gallon jug of hardener in your 10-gallon kit.  Set each 5-gallon jug on a workspace surface that is strong enough to support the weight of the jugs and large enough so that you can place each jug on its side once set up and ready to pour.

 

 

STEP 2

Remove the cap using an adjustable wrench. Next, remove the red seal. 

 

STEP 3

Drill out an approximately 3/4" diameter hole, which will be indicated with a circle as a guide on the cap.  Screw the cap and the nozzle in to the jug. 

 

STEP 4

Set the container on its side to pour.

STEP 5

To open the vent, turn the blue cap. You may need to use pliers to turn the blue cap initially.

 

Tip: Always store the jugs right side up to help avoid unwanted drips and spills.

 

Time to Start Your New Project

It’s time to get started on your project! Follow the 5 easy steps in this article and if you have any questions or concerns about anything at all, just let us know! We're happy to help answer any questions you may have about our products or how they can benefit your next project.

You can also check out our blog on How to Keep a Clean Workspace with Art 'N Glow Epoxy Resin.

 


Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.